Burnishing Ball

Burnishing Ball T01-20379. For best results when acquiring a 2D/3D parameters and images from the PosiTector RTR 3D, it is recommended to use the supplied burnishing ball instead of the stainless-steel burnishing tool. It is recommended with analyzing features larger than 1 mm. To Use : Apply sufficient pressure in a circular and x-y rubbing motion to produce a replica with a uniform appearance. Excessively hard rubbing should be avoided because the polyester film could become distorted. It normally takes 30 to 60 seconds to fully compress all parts of the foam on most surfaces. Once complete, remove the replica tape from the surface. It is important to clean the anvils and camera lens before each measurement of 2D and 3D parameters or generating SDF files. This tool is recommended when obtaining 2D/3D parameters or generating SDF files.